When reinstalling the I/O board, carefully align the
WIFI switch
to sit in the switch extender.
WIFI switch (white tab) sitting in switch extender (black channel)
When replacing the
top cover
, tilt the back down so it will slip under the LCD hinges. Lower the front into
place. There are small tabs all around the cover which help hold it in place. Be sure these tabs all latch
into place before screwing it down. Look at the photos shown in the disassembly section for the screw
locations.
When reinstalling the
touchpad
and
keyboard cables
, make sure the cable seats all the way into
position before lowering the black lock bar.
When reinstalling the
keyboard
place the spacebar edge of the keyboard in place first. It has tabs which
must go under the edge before the rest of the keyboard can drop into place. Gently press the top of the
keyboard down until the 3 latching tabs pop into place.
When reinstalling the screws on the bottom, the short ones go in the battery compartment.
Don’t forget to get the feet from where you stored them (on the battery, perhaps) and put them back in
place.
