System Board
1-11
1.6.5
Reconfiguring the System
You must enter Setup after installing or removing SIMMs to
reconfigure the system.
Follow these steps to reconfigure the system:
1.
Turn the system on. A memory error message appears,
indicating that the total memory does not match the value stored
in CMOS.
2.
Press
+
+
to enter Setup. A warning message
appears indicating an incorrect memory configuration.
3.
Press
twice to exit and reboot the system.
The system boots with the new memory configuration.
If you run WindowsNT, NetWare, or
UnixWare in the system, make sure to run
ECU every time you change the memory
size. See Chapter 4 for information on ECU.
