36
explanation to configure the AcerRouter 101/201.
Chapter 5 Troubleshooting
This chapter provides the solutions to problems occuring during installation and
operation of the AcerRouter 101/201. Please check the following to solve problems.
Problem & Symptom
Possible cause & Solution
Hardware-
The LAN Tx/Rx LED is off
Modem is not able to dial out
Check all the connections and make sure that they are well connected.
Make sure that your hub/switch is correctly connected to “ Hub” , or your PC to “ Node” .
“ Hub” and “ Node” can not be used at the same time.
Make sure that your Ethernet card is installed properly.
Make sure all the physical connections are well-connected and the Modem is powered
on.
Make sure a working phone line is connected to the Modem.
The number may need to be added with prefix such as “ 0,” to get an outside line. The
comma stands for the connection waiting time.
I Can’ t browse to the IP Gateway Check the TCP/IP setup on your PC.
Run “ winipcfg” under Windows 95/98 prompt DOS or
run “ Ipconfig” under Windows NT prompt DOS. The PC should have an IP address of
192.168.1.x (where “ x” is from 1 to 254.).
If you use fixed IP, you have to set client station IP address in the range of 192.168.1.2
~ 192.168.1.252 except 192.168.1.100 ~ 192.168.1.149, default gateway as
192.168.1.1 and DNS IP as your ISP’ s DNS IP.
If the computer has previously used Dial-up networking for Internet access, you have to
make the following changes:
l
Click
Start
,
Setting
and
Control Panels
l
Double click the
Internet
icon and then click
Connection
tab
l
Select
Connection to the internet using a local area network
l
Click
OK
to finish.
