2-4
User’s Guide
Select the ‘Netkey’ which is the ID of the network. Please be noticed that all of the
stations in the same network should have the same ‘Netkey’
15. If the setting is not done properly, the setting request will be popped out every ime you start
your PC.
16. Now your Warplink should be working properly. If there is any problem regarding the setup,
please refer to the ‘Troubleshooting’ section.
& " #!
To install the SYGATE software, please refer to the installation manual provided with the
software for instructions.
' (
The Warplink utility could be used to monitor your network quality and manage your network.
The Warplink utility could be run from the Start Menu. There are four sections of the utility.
1. Warplink Status
The Warplink station name for this PC is shown.
Warplink station type is shown. (Network Host or Network Client)
The hopping sequence for this network is shown.
The Warplink MAC (Media Access Control) address is shown, this follows IEEE
standard. You would be able to set it.
The Station name, station type and hopping sequence could be set in ‘Warplink
Setting’ menu.
‘Co-ord Quality’ – the link quality for this station to ‘Network Host’.
‘Processor Usage’ - the Warplink processing power usage. It indicates how busy
the Warplink is.
2. MAC Statistics
- MAC status monitor. By this, you will see the wireless link quality.
3. Warplink Setting
This is used to set up the Warplink station.
‘Network Host’ – the master of the entire network, control the network timing and
operation sequence. Only one station could be set as ‘Network Host’ in a network.
‘Network Client’ – All the non-Network Host stations are Network Client.
‘Station Name’ – the name used for this station. And this is the name will be shown
and seen in the Warplink network. Up to 16 characters.
