Installation and Operation Manual
Chapter
3 Operation
ACE-3105, ACE-3205 Ver. 5.2
Default Settings
3-3
Name LED
Color
Function
Red
On: SHDSL link is not detected
Off: SHDSL link is detected
Blinking: Read and green, SHDSL is training in
LINK
(ETH Ports)
Green
On: Ethernet link is detected
Off: Ethernet link is not detected
ACT
(ETH ports)
Yellow
On: ETH frames are received or transmitted
Off: ETH frames are not received and
transmitted
SYNC
(E1/T1/J1 ports)
Green
On: The physical layer is synchronized
Off: The physical layer is not synchronized
Blinking: RAI alarm was detected
3.3
Default Settings
Login Defaults
There are three levels of user access rights:
•
su – can perform all the activities supported by the management facility
•
tech – can monitor the operations and initiate diagnostic tests
•
user – can monitor the operations only.
The default passwords for these access levels is “1234”.
For security reasons, it is recommended to periodically change your password, as
explained in
Configuration Defaults
ACE-3105, ACE-3205 comes with factory defaults. It is possible, however, to
change these defaults and save any current configuration as user default
configuration, as explained in
Saving/Deleting the Default Configuration File
Chapter 4.
Additional parameters suggest default values that become active only when
saving the configuration.
In some cases, values must be entered manually, otherwise the configuration
cannot be completed.
Note