Accutech LC1400, Installation Manual

Page: 49 / 72

3-5 Chapter 3: Tags, IDTAD, & TTS
To attach WW tags:
1) Feed the flat end of the band strap into
the slot on the side of the tag with the
word "accutech" on it. Push the band
through until the end emerges from the
other side.
2) Pull the band through the tag until the
the tag sets onto and stops at the risen
part of the band.
3) Wrap the band around the resident's
wrist, feeding the single-hole end of the
band through the slotted end. Line up
the holes on each end of the band to
determine which sizing hole the rivet
should be inserted into for the best fit.
The fit should be as tight as possible
without sacrificing the resident's comfort.
Important: The band cannot be adjusted
again once it is secured.
4) Insert the male end of the rivet through
the inner side of the band and into the
selected sizing hole. Fit the single hole on
the other end of the band onto the rivet
as well.
5) Fold the rivet over so the female and male
ends are lined up. Squeeze them together
tightly. You may hear a click or feel the
teeth of the rivet come together. This
ensures a secure connection.
6) Test the fit by using a small amount of
force to confirm the rivet can not be
removed. If the rivet comes apart during
this test, attempt to secure the rivet
again. If necessary, replace the rivet.
7) Use the IDTAD to activate the tag.
Figure 3.9
Securing the rivet on the WW Tag