Accusys TShare A16T3-Share, User Manual

Page: 4 / 63

Preparing to Install Tshare A16T3-SHARE
To ensure safe and smooth operation of your Tshare A16T3-SHARE, it is essential that you
choose an appropriate location for the system, and provide an appropriate operating
environment and adequate power for all components of the system. As you plan for
installation, follow the guidelines below to ensure that the system and its environment are
safely and appropriately positioned for efficient operation and service.
Precaution for Handling the System
Take the following precautions to avoid damage to the system or potential injury to you.
1. Prepare a flat, sturdy surface before removing the system from its packaging. The table
or cart that will hold the system should be as close as possible to the system’s carton.
2. Ensure that all power switches have been turned off and all power cords disconnected
to prevent personal injury and damage to the hardware.
3. Static electricity can damage electronic components of your system. Follow the
guidelines below to avoid such damage:
a. Work in a static-free environment
b. Wear a grounded anti-static wrist strap
c. Store uninstalled components in anti-static bags
d. Handle circuit boards by their edges and avoid touching chips and connectors
Choosing the Location for the System
The Tshare A16T3-SHARE is designed as a rack-mount solution. Depending on where your
rack is located, you should keep the following points in mind when determining where to
place your system.
1. Measure the amount of available space in the rack. The amount of space required for
the A16T3-SHARE is 3U rack space. (dimensions are : L: 567mm W:441mm H: 131mm)
2. Measure the distance between any two components that need to be connected via
cable(s). This measurement will help you determine the length of the required cable(s).
Or if you’ve already purchased the cables, determine the proximity of the components in
question.
3. Leave sufficient room, at least two inches, around the unit to allow air ventilation.
4. Do not block or cover any of the ventilation holes in the front and back panels of the
unit. Consistent airflow is essential to keeping the system operating efficiently.
5. Allow additional room at the front and back of the unit for service.
6. The Tshare A16T3-SHARE uses several cables and cords. It’s a good idea to determine
how they will be arranged at the rear of the system, and where the cables will be routed
to connect to the host systems and RAID disk systems.
Electrical Power