Chapter 5 – Configuration
51
Setting fibre parameters
The parameters of the fibre channel connection(s) to the host(s) are set and reconfigured
from the Fibre Params submenu located at Main menu > Fibre Params menu.
ACS-8960 is available in two hardware configurations: With a fibre channel
interface and with a SCSI interface. The Fibre Params menu is only present on
the fibre channel interface configuration. User of the SCSI interface model
should ignore this section.
2 Fibre paramn
2.1 Primary FC
2.2 Secondary
FC*
Enable / Disable
Arbitration Loop /
Point-To-Point
1 Giga Bits / 2 Giga Bits /
Auto-Negotiated
Match slices in existing
arrays to up to 8 LUNs
2.1.1 Enable Hard
Loop ID
2.1.2 Set Hard Loop ID
2.1.3 Set Connection
Mode
2.1.5 Lun map
2.3.1 Visible for all
hosts
2.3.1.1 Port1
2.3.1.2 Port2
Enable /
Disable
2.3.2 SAN Mapping
2.3 SAN Mask
Enable /
Disable
2.3.2.1 Port1
2.3.2.1.1~2.3.2.1.8
Select Host
Select
LUN
Yes /
No
2.3.2.2 Port2*
2.3.3 Edit WWN Table
2.3.4 View WWN
Table
2.3.5 View SAN
Mapping
2.3.3.1~2.3.3.8
Select Host
2.3.5.1 Port1
2.3.5.2 Port2
*submenus as for
Primary FC
*Submenus a for 2.3.2.1 Port1
2.1.4 Set Data Rate
