2
Before starting the installation process, the slides must be dis-
assembled into the individual three members. Extend the slide
members and follow the steps as shown in Figure 5. Remove the
drawer member and then follow steps shown on Figure 11 and 12
to remove the intermediate member.
Drawer Member Mounting
To install the drawer member,
secure inner member to drawer.
(Welding is optional). See Figure 1.
Mounting Instructions
Drawer Front
Figure 1
Cabinet Member Mounting
Align the cabinet member (outer member) at the proper height so
that the drawer can be inserted with no interference. Install the
cabinet member using #10 hex screws, and ensure slides are
parallel. See Figure 2.
To modify angle, remove screws 1 and 3 and rotate around
screw 2 to desired angle and reinstall, as shown in Figure 3.
Figure 3
Flat (0°) Mounting 2° Back Angle
4° Back Angle
Angles may vary by slide length
Figure 4
Intermediate Member Insertion
Insert intermediate member into the installed cabinet member,
as shown in Figure 4.
Drawer Insertion
Before starting drawer insertion, ensure the following:
•
Intermediate member should be nested inside cabinet
member.
•
Extend intermediate member and
lift
the drawer release lever
as shown in Figure 5.
WARNING: Drawer release lever must be
up
to insert drawer.
Figure
5
NOTE:
Member does not come with pre-drilled holes.
Recommended use of #8 hex flathead screws.
Screw 2
Screw 3
Screw 1
Cabinet
Cabinet
Front
Instop
Cabinet
Figure 2
