●
1
●
2
Set the power switch of the preamplifier to OFF.
Remove the sub panel of the expansion slot on
the rear panel. Use the supplied hex wrench to
remove the four screws by turning them coun-
terclockwise (see Fig. 1).
The removed sub panel is not used.
●
3
●
4
Slide the AD-2810 into the preamplifier along the
two guide rails on both sides (see Fig. 2). When
you feel a certain resistance, give the AD-2810 a
slight push until the connector is fully plugged
in. When the AD-2810 is flush with the rear panel,
it is inserted correctly.
Use the four screws to fasten the AD-2810 by
turning the screws clockwise.
PHONO EQUALIZER UNIT
Instruction Manual
Installation
Guide rails
Hex wrench
Sub panel
Phono Equalizer Unit
AD-2810
Fig. 2
Fig. 1
Expansion
slot
Thank you for purchasing the Phono Equalizer Unit AD-2810.
This unit is designed for installation in the preamplifier models listed below, to provide
analog disc reproduction capability. After installation, all functions are operated with
the controls on the front panel of the preamplifier. For details about use, please refer to
the instruction manual of the preamplifier in which the unit is installed.
●
Be sure to set the power switch of the preamplifier to OFF before inserting or
removing the AD-2810. Otherwise damage may occur.
●
Do not touch the component side, solder side, or connector of the AD-2810.
Otherwise static discharge may cause damage, and contact problems may occur.
●
Make sure that all four screws of the are securely fastened. Otherwise a floating
ground condition may occur, which can lead to damage.
J071.5X
820-3248-00(K1) Printed in Japan
ACCUPHASE LABORATORY, INC.
2-14-10, SHIN-ISHIKAWA, AOBA-KU, YOKOHAMA 225-8508, JAPAN
CAUTION
AD-2810
＊
Supportedmodels : C-2810, C-2800, C-2410, C-2400, C-290, C-290V
