9
BATTERY:
Battery information
Capacity: 110mAh Voltage: DC 3.7V Restriction: 4.2V
Charging the Battery
1) The Lithium battery can be recharged through both the AC adaptor and a computer USB input.
2) Turn off the unit.
3) Connect the unit and the charger with the USB cable. Plug charger into any power outlet and a red light will show when it is
charging. The charging process will take approximately 1 hour. When charging is finished, the LCD will show a full battery cell.
4) The battery should be charged for 10 hours or so before the first use.
NOTE:
Only charge the unit when battery is completely drained the first 2 times. Unplug the charger from power outlet when
charging is complete. When stimulation intensity decreases, it indicates that the device needs charging. Recharge it and then
continue to use the device. Do not use the device while charging.
CLEANING AND MAINTENANCE:
A.
FOR THE CONTROL UNIT:
1.
To keep the controller clean, use a soft, dry cloth for dust or a soft damp cloth for any dirt and smudges. Do not use any
cleaning solutions to clean the controller and its pads.
2.
Do not use or store the device where there are magnetic fields or electric waves (near TV set or speakers).
3.
Do not place the devices in areas of high temperature, high humidity, or under direct sunlight.
4.
Keep the device out of reach of children.
5.
All worn accessories should be disposed of according to your local regulations.
B.
FOR ELECTRODE PADS:
1.
Unplug the output cord from the output jack of the controller after each use. Cover both pads with the protective film before
storing. Never fold the electrode pads.
2.
Between uses, store the electrodes in the reusable bag in a shady place. Stock room temperature: +5°C~+27°C (41-80°F) and
humidity of 30%~80%. No need to sterilize.
3.
Never apply the pads to any other surface other than your skin. If the pads become soiled or dirty, the adhesiveness may
decrease. In this case, moisten the surface of the pads with water and wipe away the dirty portion. This will allow a temporary
restoration of the adhesiveness. However, too much water will result in loss of the adhesiveness.
4.
The life of the electrodes varies depending on skin conditions, storage, amount of use, type of stimulation, and stimulation site.
Electrode life may be extended by carefully following this Instruction for Use. The expired electrodes are to be recycled to not
harm environment.
WARNING
: The electrodes are intended for single patient use only!
STORAGE:
CAUTION: Do not store in a damp area. Dampness may affect the device and cause rust.
•
Normal working ambient temperature: 5°C~40°C (40-104°F)
•
Normal working ambient humidity: ≤80%RH
•
Store and transport ambient temperature: -20°C~55°C (4° -131° F)
•
Store and transport ambient humidity: ≤93%RH
HOW TO STORE DEVICE:
1.
If you need to turn off the device during stimul
ation, slide the On/Off switch to “OFF”.
2.
Before storing the TENS use the protective film to cover the electrode pads.
3.
Put away the connecting wires and electrode pads.
Summary of Contents for AP212
Page 14: ...14 ...
