ACCUDUAL
Touch-kit
2
Upper and bottom view of ACD-10203:
Function description
1.
Switch button for input signal selection
: Offering switch input
signal between VGA port and 25pin D-sub signal (AMAT machine)
2.
Switch button for operation mode selection
: Offering change
between using light-pen and finger tip to operate system
alternatively.
3.
LED indicator for operation mode selection
: Green LED lit to
indicate that it is operated under light-pen mode.
4.
Access indicator & monitor calibration button
: The button
with built-in LED indicator. Press and hold 3 seconds then release to
enter to calibration mode, the built-in LED lit to indicate the monitor
is accessed.
5.
Touch pen plug
: RJ-11 type, for connecting the original light-pen
of AMT system or touch pen.
6.
25 pin DB type connector
: DB-25 type, for receiving the VGA
signal from AMAT system.
7.
15 pin D-sub connector
: Standard VGA display port for PC.
8.
RS-232
: a phone jack type RS-232 for R/D debug port.
9.
DC Power input
: Providing DC power to ACD-10203 from adapter.
Introduction
1
1
Switch button for input signal
selection
2
Switch button for operation mode
selection
3
LED indicator for operation mode
4
Access indicator & monitor
calibration button
5
Touch pen connector
6
25 pin DB type connector (for
AMAT machine)
7
15 pin D-sub(VGA port)
8
RS-232
9
DC Power input
Caution
For the safety concern,
turn off
and disconnect all
electrical power from the system before beginning
installation.
