Accucold FFAR24L Instruction Manual Download Page 5

 

INSTALLATION INSTRUCTIONS 

 

Before Using Your Appliance 

  Remove the exterior and interior packing. 

  Before connecting the refrigerator to the power source, let it stand upright for approximately 2 

hours. This will reduce the possibility of a malfunction in the cooling system from handling 
during transportation. 

  Clean the interior surface with lukewarm water using a soft cloth. 

 

Installing Your Appliance 

  This appliance is designed to be free standing only, and should not be recessed or built-in.

 

  Place the appliance on a floor or other surface that is strong enough to support it when fully 

loaded. To level your appliance, adjust the leveling leg at the bottom. 

  Allow about 5” (12 cm) of space at the back and sides of the appliance and 4” (10 cm) at the 

top. This will allow the proper air circulation to cool the compressor. 

  Locate the appliance  away from direct sunlight and sources of heat (oven, heater, radiator, 

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical 
consumption. Extremely cold ambient temperatures may also cause the refrigerator  not to 
perform properly. 

  Avoid locating the appliance in moist areas.  

  Plug the appliance  into an exclusive, properly installed and grounded wall outlet. Do not 

under any circumstances cut or remove the third (ground) prong from the power cord. Any 
questions concerning power and/or grounding should be directed toward a certified electrician 
or an authorized service center. 

  After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before 

placing items inside the cabinet. 

 

Electrical Connection 

 

 

 

 

This appliance should be properly grounded for your safety.  The power cord is equipped with 
a three-pin plug which mates with standard three-prong wall outlets to minimize the possibility 
of electrical shock. 

 

Do not under any circumstances cut or remove the third ground prong from the power cord 
supplied. 

 

This  refrigerator  requires a standard 115Volts AC~ 60Hz electrical outlet with three-prong 
grounded receptacle. 

 

To prevent accidental injury, the cord should be secured behind the appliance  and not left 
exposed or dangling. 

 

Never unplug the refrigerator by pulling the power cord.  Always grip the plug firmly and pull 
straight out from the receptacle. 

 

Do not use an extension cord with this appliance. If the power cord is too short, have a 
qualified electrician or service technician install an outlet near the appliance. 

Warning

 

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord 
is damaged, have it replaced by an authorized service center. 

 

 

Summary of Contents for FFAR24L













Reviews: