7104 NW 50 Street, Miami, FL 33166 USA • 1-888-993-2228 •
www.AccuBANKER.com
AccuSTAND
Installation Guide for: D585
Parts needed
Vertical
surface installation
Horizontal
surface installation
1. Metal stand (1pc)
2. Holding screws (4pcs)
3. Rubber feet (2pcs)
4. Thumb screw (2pcs)
1. In the location where the detector will be
installed, make two point marks 85 mm
from each other
Fig. 2, hole D
in a horizontal
position to install the holding screws.
2. Tighten the holding screws into the
surface/wall to support the metal base.
3. Proceed to set up the metal base with the
detector as described in the instructions
below (horizontal surface installation).
1. Place the rubber feet into the two holes
labeled
C
in
Fig. 1
2. Tighten the two thumb screws into the
metal thread holes located in the bottom of
the unit, labeled
E
to secure the unit to the
AccuSTAND as is shown in
Fig. 4
, using the
threaded hole
E
indicated in
Fig. 3
.
45°
15°
Fig.
3
Fig.
4
E
Fig.
2
B
D
C
70
85
44.
7
120
150
50
A
Fig.
1