1
0
1.
Connect the power cable to the detector and then connect the adapter to the power
outlet.
After turning on the detector, the equipment will begin a self-check process
that
lasts
about
5 seconds. The
display will read 0
, which
means that the equipment is
ready to check the bills.
I
f there is
any error code, refer to the
Error Messages section
of this user guide on page 18
.
2. Select the type of currency to be
verified (USD-EUR-GBP
) by pressing the
CURRENCY
button.
3.
Insert the
bill
to be checked
into the feeding channel (insert
in any direction
)
.
When
a
bill is presented at the feeding channel, an optical sensor located in the this
compartment
allows the detector
to
automatically begin the verification process. The
bill will pass
through the
equipment and be analyzed immediately.
4.
The detector will verify the
bill
and show the denomination as confirmation
that it is
genuine. Its value will be added to the verified total.
5. If a bill is suspicious, it will be rejected and there will be two audible warnings. Its
value will not be added to the current verified total. The error code corresponding to the
suspect security parameter will appear on the screen as well as the word "FAILED". The
suspicious bill will then be rejected forward (even if the bill exit direction has been set
to exit through the back of the equipment).
3. Operation
3.1 Basic Operation
