AccuAir e-Level+ Quick User Manual Download Page 4

Page: 4 / 4

Use the following error codes to identify what is not functioning correctly.
Provide this information to your installer or to AccuAir Tech Support:

(805) 481-6500

Flashing Trouble Codes

All 3 Position Buttons flash simultaneously to indicate an error

If both UP and DOWN red
arrows on a corner are red,
then the sensor is not
connected or is not reading
as expected electrically

Up or Down Strobing Red Arrows

If the red arrows are
strobing UP, it indicates
that your vehicle voltage is
ABOVE 16 volts

If the red arrows are
strobing DOWN, it indicates
that your vehicle voltage is
BELOW 10.5 volts

A RED up or down arrow
alone indicates a
non-functioning valve, or
mechanically disconnected
sensor

Tank pressure is NOT

increasing as expected

2 FLASHES

Verify all tank ports are
plugged

Pressure Sensor not

detected

Check that it’s
connected

4 FLASHES

Height Sensor travel too

small during calibration

3 FLASHES

Re-check sensor travel

Sensor Corner

Association Error

5 FLASHES

Verify correct plumbing
and sensor wiring

The corner arrows will turn red to indicate sensor or valve errors

Corner Error Indication

Error Codes

Summary of Contents for e-Level+

Page 1: ...ESSOR STATUS INDICATOR INDIVIDUAL CONTROLS REAR CONTROLS Saving Heights Must Be Calibrated To save a new height manually adjust the vehicle to the desired position Once confirmed hold the position 1 2...

Page 2: ...justments Accuracy 2 Factory Accuracy 1 Less Accurate Fewest Adjustments Settings i To change your system settings from the TouchPad momentarily press the program button and then make adjustments with...

Page 3: ...n starts Automatic Calibration This will learn the sensor travel and suspension parameters for the first time i Hold the Program Button and Position 2 at the same time until calibration starts Recalib...

Page 4: ...volts If the red arrows are strobing DOWN it indicates that your vehicle voltage is BELOW 10 5 volts A RED up or down arrow alone indicates a non functioning valve or mechanically disconnected sensor...