EXI-600 INVERTED MICROSCOPE SERIES
ACCU-SCOPE
®
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
22
5.2.15.
Camera adapter
Remove dust cap from a camera
port by pulling straight off.
Thread a camera adapter onto the
camera.
To avoid getting dust onto the
camera sensor or inside the
camera adapter, hold them both in
a horizontal orientation when
threading them together.
Thread the camera adapter with
attached camera onto the side
port.
Orient Camera Image
After installing the camera, the
image to the monitor may be in a
different orientation than seen
through the eyepieces.
Loosen the camera adapter locking
screws (3 total) with a 2mm hex
screwdriver.
Compare the image on the monitor
with the image seen through the
eyepieces, and rotate the camera
until the orientation is the same.
Tighten the locking screws to
secure the camera orientation.
Camera adapter
locking screws
