EXC-350 MICROSCOPE SERIES
ACCU-SCOPE
®
73 Mall Drive,
Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
9
ASSEMBLY
(continued)
Condenser
The condenser was installed and centered by our
technicians prior to delivery. If the condenser needs
to be re-installed or adjusted in the future, rotate the
coarse focusing knob
①
to raise the stage to the
highest position (see Fig. 1).
Rotate the condenser up-down knob
②
to lower the
bracket of condenser to the suitable position.
Fully loosen the condenser lock-screw
③
.
Insert the condenser into the hole of the stand
according to the directional arrow, until the
condenser is even with the stand, and then rotate
the condenser to make sure the iris diaphragm
control lever faces forward.
Tighten the lock-screw
③
of the condenser, then
raise the condenser with the up-down knob to the
highest position.
Objectives
Rotate the coarse focusing knob
①
to lower the
stage to a suitable position (see Fig. 2).
Install the objectives into the objective nosepiece
②
from the lowest magnification to the highest in a
clockwise direction from the rear.
Eyepieces
Remove the eyepiece caps
①
.
Insert the eyepiece
②
into the eyepiece tube
③
until it touches the surface of the eyepiece tube
.
Repeat above for the other eyepiece (see Fig. 3).
Fig. 1
Fig. 2
Fig. 3
①
③
②
①
③
②
①
③
②
Summary of Contents for EXC-350 Series
Page 2: ......