Cheetah PCI Adapter
11
• Make sure the correct software driver is installed for your
operating system. If necessary, try reinstalling the driver.
• Make sure the computer and other network devices are
receiving power.
• If the adapter’s speed or duplex mode has been configured
manually, check that it matches that of the attached
network device port. Note that it is recommended to set the
adapter to auto-negotiation when installing the network
driver.
• The port on the network device that the adapter is
attached to may be defective. Try using another port on
the device.
Compliances
FCC Class B Certification
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
Warning!
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from the one which the receiver is connected to.
•
Consult the dealer or an experienced radio/TV technician
for help.
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void
your authority to operate the equipment.
Attach shielded or unshielded Category 3, 4 or 5 twisted-pair
cable to the RJ-45 port.
Note:
In order to maintain compliance with the limits of a Class B digital device,
Accton requires that you use a quality interface cable when connecting to this
device. Changes or modifications not expressly approved by Accton could void the
user's authority to operate this equipment. Suggested cable type is 100
W
shielded
or unshielded Category 3, 4, or 5 twisted-pair cable for the RJ-45 port.
Summary of Contents for Cheetah PCI Adapter
Page 1: ...Cheetah PCI Adapter Quick Installation Guide...
Page 2: ......
