3
re-calIbratIng the Watch hands for radIo controlled
Note: Only calibrate the watch hands after changing the battery or when the watch is not setting correctly.
a)
Watch Hand Calibration for RCC function
To reset the hands to zero (12:00) position, please follow below steps:
1. Pull out the crown when the second hand is at 12:00 position.
2. Turn the crown to set the hour and minute hands to 12:00 position.
3. Gently push back the crown to normal position. (Please push the crown softly in case the second hand moves)
4. Press Button (B) or Button (C) to start SYNC for the accurate time
b)
Quick calibration for second hand.
Your watch is a very delicate and precise instrument. Although uncommon, sometimes hard knocks or vibrations can cause
the hands to move irregularly, and therefore display the incorrect time, although the internal clock is keeping accurate
time. You may notice this if when you press button (A). If the second hand does not point at “OK” or “NG”, this means the
second hand is off. Please follow below steps:
1. Press Button (B) or Button (C) and the second hand will turn to 12:00 position.
2. If it is off, you can press button (A) to forward the second hand to 12:00 position within the first 20 seconds after pressing
Button (B) or Button (C).
After calibrated the second hand, the watch will start SYNC for the accurate time.
auto-synchronIzatIon
Once batteries are installed and calibrated the watch hands for radio controlled function, the receiver circuit is activated.
The second hand will point at 12 o’clock position and all hands will stop running. If the watch is too close to electrical
appliances such as TV, mobile phone and computer, they may cause undesirable signal interference. Strong signal is
normally found close to the window. In some areas where the signal is poor or less, you may need to position and rotate the
watch close to the window. (See Fig.4).
Fig.4 Watch attempting to synchronize when it is at 2:00 a.m.