10
Figure 8.3
4. To move the handset cable to the right
side of the bed, remove the handset
cable connector from the left side socket.
Insert the captive blanking plug into the
socket.
5. Remove the plug from the right side
socket and insert the handset cable
connector.
6. Ensure the bed is positioned so that the
mains plug can be easily put into a mains
socket. Plug the power supply cable into
a mains supply socket.
7. Using the handset, raise the bed to the
highest position, see section 10.
8. The headboard and footboard fixing kit
comprises the following items:
1. 2 x left fixing brackets
2. 2 x right fixing brackets
3. 8 x M8 x 20 bolts
4. 8 x M8 x 35mm bolts
5. 24 x M8 washers
6. 8 x M8 locking nuts
7. 1 x 5mm Allen key
9. Position the brackets on the footboard as
– note the orientation of the
brackets.
Figure 8.4
10. Fix the brackets to the footboard using
the M8 x 35 bolts, nuts, and washers
provided as shown in Figure 8.5. Tighten
using the 5mm Allen key and a 13mm
spanner.
Figure 8.5
11. Repeat steps 9 and 10 to mount the
brackets to the headboard.
12. Take the footboard and locate the
mounting brackets into the channel
sections on either side of the foot end of
the bed; slide the footboard and brackets
all the way into the channels as Figure
8.6.
13. For the bed at the standard length for a
200cm mattress, use the bolt holes
marked ‘Standard’ in Figure 8.5. For the
bed at the extended length for a 220cm
mattress, use the bolt holes marked
‘Extended’ in Figure 8.5.
Figure 8.6
Standard
Extended