500VA
1000VA
2000VA
1
NOTE:
Before installation, please inspect the unit, to ensure that nothing
inside the package is damaged and/or missing.
Connect to Utility Power and Charge
Plug the AC input cord into the wall outlet. The unit will automatically start
charging any connected external batteries even though the unit is switched off.
Single Battery Connection Voltage (Refer to Fig 1):
When using any batteries, the voltage must be equal to the Nominal DC
Voltage of the unit (see below Table 1).
Mounting the Unit
The unit can be mounted onto a wall surface by following the below steps:
1. Turn off and disconnect the unit before attempting to mount the unit.
2. After selecting an appropriate mounting location, use a horizontal line with a
length of 205 mm and mark the ends of the line on the wall. (See chart 1)
3. Drill and insert two mounting screws at these marks, one each.
4. Mount the unit by positioning the key-hole slots over the mounting screws and
sliding the unit till securely attached.
Summary of Contents for Mi500
Page 1: ...INVERTER...
Page 8: ...4256 9255...
