A121 Integration using STM32CubeIDE
1
Introduction
In this document there will be a short guide with example on how to generate a project and setup the Acconeer software
in STM32CubeIDE.
The MCU board used as an example in this guide is a Nucleo-L476RG. We will show how to connect an XE121, including
the A121 radar sensor. There is some extra logic on the XE121 board to support multiple sensors that typically is not
present on boards with only one sensor. To show how a typical single sensor integration can be done, we have also
included some notes on how to use the XE121 in a single sensor setup.
STM32CubeIDE can be downloaded from the ST website at:
https://www.st.com/en/development-tools/stm32cubeide.html
This guide has been verified in both Ubuntu 20.04 and Windows with STM32CubeIDE 1.9.0
© 2022 by Acconeer AB - All rights reserved
Page 3 of 23
