4
TROUBLESHOOTING GUIDE
SYMPTOM
POSSIBLE CAUSE
SOLUTION
Lights
will
not
1.Light switch is turned off.
2.Fuse is blown or circuit breaker is turned off
3.Daylight turn-off is in effect
4.Incorrect circuit wiring,if this is a new installation
5.Light control aimed in wrong direction
come
on.
Lights come
on
in
day
-
light.
1.Light
control may
be
installed
in
a relatively
dark location.
2.Light
control
is
in
TEST.
Lights come on
for no
apparent reason.
1. Light control
may
be
sensing
small
animals
or
auto
-
mobile
2. Range
is
set
too
high.
Lights
stay
on
1. A flood lamp is positioned too close to the light
control or pointed at nearby objects that cause
heat to trigger the light control.
2. The light control may be picking up a heat source
like an air vent,dryer vent,or brightly painted ,
heatreflective surface.
3. Light control is in manual mode.
continuously.
on and
1.Heat or light from the flood lamp may be turning the
light control on and off.
2.Heat being reflected from other objects may be turning
the light control on and off.
3.Light control is in the TEST mode and warming up.
off.
Lights flash once, then
stay
off
in
manual
mode.
Light control
is
detecting
its
own lights.
the
light
control relatively dark.
SPECIFICATIONS
Range ........
Up to 40 ft.
(12 m)
[varies
with surrounding temperature]
Sensing Angle ..... Up to 180°
Electrical
Load...
Up to 24 Watt Maximum LED
Power Requirements . 120 VAC, 60 Hz
Operating Modes .
.
O
TEST, AUT and MANUAL
MODE
Time Delay ......
1 5
minutes
1.Turn switch on.
2.Replace fuse or turn circuit breaker on.
3.Recheck after dark.
4.Verify wiring is correct.
5.Re-aim light control to cover desired area
1.The fixture is operating normally under
these conditions.
2.Set control switch to 1 or 5 minutes
traffic.
1.Re-aim light control
2.Reduce range.
3.The fixture is operating normally under
these conditions.
1.Reposition the flood lamp away from the
light control or nearby objects.
2.Reduce range.
3.Switch light control to AUTO
Lights flash
1.Reposition the flood lamp away from the
light control
2.Reposition light control
3.Flashing is normal under these conditions
Reposition fliid lamp to keep area below
.
