AU Industrial Brush Cutter
Rev. 7:17
Page 5
Clean debris from the motor area.
Check that all guards and safety equipment are in good condition.
Weekly Inspection
Check blade bolts for correct torque (500 foot/pounds).
Check all bolts for tightness.
Inspect the deck for cracks, bends, or damage.
Inspect discharge chains and replace any missing or broken chains.
Monthly Inspection
Inspect the entire drive system, including motor, and bearing housing.
Inspect the blades for cracks, bends, or excessive wear.
Check skid plates for wear.
Inspect the bolts on the motor. Tighten if required.
Check that all bolts are tight.
Inspection Checklist
Are all safety notices and warning stickers in proper locations and visible?
Are all safety guards properly installed and in good condition?
Are there any visible hydraulic leaks?
Is there oil visible in sight glass?
Is there any wire or vines wound under the deck?
Are any cracks visible in brush cutter structure?
Are the blades worn, bent, or broken?
Has all debris been removed from the motor area?
Has the carrier machine been properly inspected for hydraulic leaks and proper tire inflation?
Has the carrier machine been properly maintained?
