2
INSTALLATION INSTRUCTIONS:
(NOTE: For additional installation assistance go online to accesscover.com
instruction manual and click on installation video.)
Unpack cover components.
Clean truck box if dirty.
COMPONENTS:
1 driver side rail
1 passenger side rail
1 element seal kit
6 clamps (long box kits 8 clamps)
1 left and 1 right tension adjuster with nuts & bolts
1 pre-rolled up cover assembly
A. Position side rail with weather
strip against inside lip of box.
Push rail forward until it touches
front of box. End of rail with
strike goes to rear.
B. At front, adjust top of rail
flush with top of box and
hold it there with assistance
of another person or with a
spring clamp.
1: INSTALLING COVER SIDE RAILS
TOOLS NEEDED:
1 - 1/2” wrench (for rail clamps)
1 - Tape measure or ruler
1 - Scissor
1 - Spring clamp optional
2 - 9/16” wrenches
(to hold rails in place while clamping) Protective eyewear
PREPARATION
Top of rail flush with top
side of box at front
Nylon
strike to
rear
NOTE: Some installs require drilling/bolting. Those kits will contain special side
rail instructions. Follow those instructions for rail attachment in conjunction with
instructions in this owner’s manual.
NOTE ON BED LINERS: With an under-the-rail drop in bed liner, installation is
possible with minimal trim cutting of bed liner at front corner of box and back by
tailgate to allow side rail to install properly. Considerable trim cutting is required
with an over-the-rail drop in bed liner.
At front set top
of rail flush with
top of box
Shape of rail may vary
This part of
the rail should
be near level
Summary of Contents for SLANTBACK Roll-Up Cover
Page 12: ...12 ...
