PROGRAMMING
Programming will vary depending on access confirguration. Follow the instructions according to your access
configuration
General Programming Information – Two ways
Remote Control: Please use the Infrared Remote Control to program the Reader. The infrared receiver
head is near the LED, so when you program the reader, please direct the Remote Control to the LED
User ID number: Assign a user ID to the access card in order to track it. The user ID number can be any
number from 0-997. IMPORTANT: User IDs do not have to be proceeded with any leading zeros
Recording of User ID is crucial. Modifications to the user require the User ID to be available
Proximity Card: Any 125KHz industry standard 26 bit EM and HID Proximity card or key fob
Sound and Light indications
Operation Status
Led Colour
Buzzer
Stand by
Red light bright
-
Enter into programming mode
Red light shines
One bleep
In the programming mode
Orange light bright
One bleep
Operation error
-
Three bleeps
Exit from the programming mode
Red light bright
One bleep
Open lock
Green light bright
One bleep
Alarm **
Red light Shines quickly
Bleeps
** Please see Reset Procedure for ALARM
Enter and Exit Program Mode Via the Remote Control
Set New Master Code Via the Remote Control
Programming Step
Remote Control Operation
1. Enter Program Mode
2. Enter New Master Code
* (Master Code) #
0
（
New Master Code
）
#
（
Repeat New
Master Code
）
#
3. Exit Program Mode
*
Set Operation Mode – Stand-alone or Wiegand (Default is stand-alone)
Programming Step
Remote Control Operation
1. Enter Program Mode
2. Stand-alone Operation
3. Wiegand Reader Operation
* (Master Code) #
72 # is factory default for stand-alone
73 #
4. Exit Program Mode
*
Programming Step
Remote Control Operation
1. Enter Program Mode
* (Master Code) #
Factory default is 123456
2. Exit Program Mode
*
ACCESS
SECURITY
PRODUCTS
LTD
