WARNING!
Protect against all pinch & entrapment points.
If entrapment points are not protected, DO NOT
install this product.
This device is intended for vehicular traffic only. Keep all pedestrian traffic including bicycles away
from any vehicular gate.
This product is a wireless device and subject to occasional communication failures. Therefore proper
safety photo beams and safety edges must be used in conjunction with the system.
I
NSTALLING
T
HE
C
AP
:
The Above Ground Cap is used to help raise the sensor and antenna above the ground for
better signal strength. It is important to secure the cap and sensor in place when
installation is complete. To install the cap and sensor:
1. Remove the standard cap from the sensor.
2. Learn the sensor.
3. Screw the Above Ground Cap securely onto the sensor
making sure the top has sealed against the O-rings.
4. Place the sensor in the hole with the alignment line on the
housing facing toward the lane of traffic.
5. Secure the housing and cap with a sealant or red heads so
the sensor and cap will not turn when a vehicle drives over it.
Installation Tip:
It may be easier to drill a few holes in the cap and secure it to the driveway using red head
screws. This will make it easier to remove for service.
AG-06x1.25
Quick Reference Guide
