0800 126 826 | [email protected]
17
Attached Extendable beams to the 120degree back
corner leg and Balance end legs as per above,
open side of the beam to face the centre of the pod.
Use nylon hammer to hit beam down into place.
Place desk tops on to the leg frame as per above.
Extend beams out so end leg aline with the edge of
the desk top.
Install screens as per above. Attached end legs frames
and extendable beams to the desk top using the
wood screws. (Desk tops will be pre-drilled for the
legs). Using the bolt supplied with the beam, Install
2 bolts front and back of each beam as per above.
Attach 120degree bracket to the 120degree back
corner leg as per above, using Bolts supplied with
the bracket.
STEP
1
STEP
2
STEP
3
STEP
4
3 POD 120DEGREE
ASSEMBLY INSTRUCTION
