Assembly Instructions / Turbocharger A100-H
4 Installing the turbocharger / 4.3 Placing the turbocharger on the bracket
© Copyright 2023 Turbo Systems Switzerland Ltd. All rights reserved.
HZTL455311P0004_EN
Rev. D
March 2023
4.3
Placing the turbocharger on the bracket
Fig. 7: Placing the turbocharger on the bracket
B
Clamping nut
C
Standard nut
u
Make sure that covers of the oil and water connections are removed.
1.
Make sure that the O-rings (03) are undamaged and positioned correctly in the slots.
2. Clean the expansion bushes (42190) and the contact surfaces of the expansion bushes in the
bearing casing.
3. Attach the lifting gear to the suspension eye of the bearing casing (42001) and loop around the
gas outlet casing.
4. Position the turbocharger on the bracket (04) and align it. If present, pay attention to the posi-
tioning pin (05) in the bracket.
5. When fixing with a standard nut (C), fit the expansion bushes in the correct position in the slot.
Safeguard against wrong fitting (only for water-cooled bearing casings)
Depending on the bracket version (04), two positioning pins (05) can be used for positioning and
safeguarding against wrong fitting of the turbocharger. Therefore the turbocharger must always be
removed from and installed on the bracket vertically.
u
Observe the instructions for the fastening variant at hand.
¡
Fastening the turbocharger with a standard nut
(A130 - A140)
¡
Fastening the turbocharger with a clamping nut
(only A140)
Page
12
/
21
Summary of Contents for A100-H Series
Page 2: ......