4
Connecting to the Site Network with Remote Power
If your device needs to be positioned some distance from either the nearest AC power outlet or site
network equipment/router using the included passive Power-Over-Ethernet (POE) injector cable will
usually simplify the installation cabling and allow for improved cellular signal strength. The POE
injector cable allows the DC power and Ethernet connection to be run to the Accelerated 6300-CX
via the Ethernet connection only.
1.
Plug the power supply unit into an AC power outlet and connect to the 12V DC lead (4 pin
connector) of the POE injector cable.
2.
Connect the male RJ45 connector plug of the POE injector cable to the site network
equipment/router.
3.
Connect a standard Ethernet cable from the RJ45 socket/jack on the POE injector cable,
(marked ‘DC OUT’), to the Ethernet port of the device.
The Ethernet connection at the PoE injector or from the LTE Router directly, should be connected to
the ATTgate WAN2 port of for backup and to WAN1 for Primary connection.
You should now be ready to use the Managed Wireless Access with 6300-CX LTE Router.
