INSTALLATION INSTRUCTIONS Part # RS505
OPERATION MODE;
(
WITH FOUR BUTTONS REMOTE CONTROL)
1. Press button# 1 on the remote
(LOCK SYMBOL)
momentarily. The module will send a signal to
LOCK all the doors.
The parking light will flash ONCE to confirm the operation.
2 Press button# 2 on the remote
(UNLOCK SYMBOL)
momentarily. The module will send a signal to
UNLOCK all the doors.
The parking light will flash TWICE to confirm the operation.
3 (A) Press button# 3 on the remote
(TRUNK SYMBOL)
momentarily. The module will send a negative
signal to the PURPLE wire on the harness to pop the trunk open or to control an external relay.
(ONLY IF THIS OPTION IS SELECTED. SOME VEHICLES MAY REQUIRE EXTRA PARTS
AND LABOR. PLEASE SEE YOUR DEALER FOR DETAILS).
(B) Press and hold the button #3 on the remote . The module will send a continuous negative signal
to the PURPLE wire on the harness to control an external relay.
(THE SIGNAL WILL BE CONTINUOUS AS LONG AS THE BUTTON IS HELD DOWN).
(THIS FEATURE IS NOT RECOMMENDED FOR TRUNK POP OPERATION).
(C) Press button# 3 on the remote
(TRUNK SYMBOL)
momentarily. The module will send a
LATCHED negative signal to the PURPLE wire on the harness to control an external
Relay. This signal will stay LATCHED until you press the #3 button on the remote again to turn
it OFF.
(THE DIP SWITCH #4 MUST BE SET TO ON (UP) POSITION TO SELECT THIS OPERATION
FUNCTION).
WARNING: IF THEIS OPERATION MODE IS SELECTED. MAKE SURE THIS CHANNEL IS
TURNED OFF BEFORE LEAVING THE VEHICLE. FAILURE TO TURN OFF THIS
FEATURE WILL RESULT IN A DEAD BATTERY UPON RETURN TO YOUR VEHICLE.
4 (A) Press the * button on the remote momentary. The module will send a negative signal to the
YELLOW/BLACK wire on the harness to control an external relay..
(B) Press and hold the * button on the remote. The module will send a continuous negative signal to
the YELLOW/ BLACK wire on the harness to control an external relay.
(THE SIGNAL WILL BE CONTINUOUS AS LONG AS THE BUTTON IS HELD DOWN).
(C) Press the * button on the remote momentarily. The module will send a LATCHED negative
signal to the YELLOW/BLACK wire to control an external relay.
(THE DIP SWITCH #3 MUST BE SET TO ON (UP) POSITION TO SELECT THIS OPERATION
FUNCTION).
WARNING: IF THIS OPERATION MODE IS SELECTED. MAKE SURE THIS CHANNEL IS TURN
OFF BEFORE LEAVING THE VEHICLE. FAILURE TO TURN OFF THIS FEATURE
WILL RESULT IN A DEAD BATTERY UPON RETURN TO YOUR VEHICLE.
ACCELE ELECTRONICS PAGE 3
