Accel Crestline Altra Series, Installation Instructions Manual

Page: 15 / 41

15
DISASSEMBLY
13
14
15
At the OPS and NOPS, remove the shoulder bolts (subject arrow
OPS shown) from water form block and save for reassembly.
At the OPS and NOPS, remove the snap rings (subject arrow OPS
shown) from the bearing housings. Remove the housings from the
press and save for reassembly.
With the housings removed, the water form hangers and spacers
can be removed. Save these parts for reassembly. Remove the
oscillator from the press.
This completes the disassembly process. Thoroughly clean all
parts saved for reassembly and check all mating parts (i.e.
vibrator housing to form hangers) for excessive wear. Replace
if necessary. This is important for proper operation of the new
Crestline
® Altra TM Series dampening system. Refer to your
Didde parts guides for the correct part numbers. Also, clean the
inside of the press frames around the dampener area.