F C C R E G U L AT O RY A P P R O VA L
U.S.A.
Contains FCC ID: W7OMRF24WG0MAMB
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interfer-
ence that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions may
cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC RF Exposure requirements for mobile and base station transmis-
sion devices, a separation distance of 20 cm or more should be maintained be-
tween the antenna of this device and persons during operation. To ensure
compliance, operation at closer than this distance is not recommended.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
CANADA
Contains transmitter module IC: 7693A-24WG0MAMB
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux con-
ditions sui vantes: (1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioelctrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
Page 7
Page 20
SPA-SIDE CONTROL PANEL 1000
FUNCTIONS
Press once to activate the low jets. Press again
for high jets. A third depression turns the jets
OFF, if the heater is off.
Press, for air bubbles or second single
speed pump if applicable. Button will be
marked “AUX”.
Light switch ON/OFF.
TO INVERT THE TEMPERATURE DISPLAY:
PRESS THE SET & UP ARROW KEYS TOGETHER AT THE SAME TIME.
