13
ARS-2212 Chapter 3 Setup and Operation
2. ARS-2212 Mirror Mode Setup (If originally set to Normal Mode)
◆
First, connect the ARS-2212 to the power supply then set the RAID Mode
switch to “Clear” as shown in the picture below:
◆
Next press the “
” button to enable “Clear” mode. The and LEDs will
now blink every second. and
1
and
6
indicators continuously light
orange with one long beep and three short beeps.
◆
Finally, set the array mode switch to “RAID1” mode and press the “ ”
button to make sure it is in “RAID1” mode. Meanwhile, the
3
LED
continuously lights up green, and the
1
as well as
6
indicators
continuously light green after flashing red for six times. If the
1
indicator
flashes orange while online, it means that the data reconstruction is
running on the second hard drive, as show below:
◆
After setting the Normal mode, one USB devices are visible in the Device
Manager. For more information about how to use the hard drives, refer to
the hard drive management section in the troubleshooting chapter.
Attention:
The Clear operation must be performed before changing the RAID mode each time.
Make sure that your data is kept in a safe place.
