Chapter 1 Introduction
1.1 Overview
The development of AEC-7730A is based on ACARD’s SCSI-to-SATA
technology, which converts a SATA hard drive into a SCSI one for the best
performance. An on-board core micro controller developed by ACARD
makes the bridge AEC-7730A more flexible and more stable in high-level
applications.
1.2 Specification
LVD SCSI interface for up to 160MB/s of transfer rate
Supports SATA hard drives
Temperature
Operation --- 0
°
C to 50
°
C
Storage ---
−
20
°
C to 85
°
C
Humidity --- 15% to 90%
Dimensions --- 9.8 (L)
j
2.5 (W)
j
2.5 (H) cm
1.3 Outline
CN1 --- 4-pin power connector
CN2 --- SATA connector (left is for power and right for data transfer)
CN3 --- 68-pin female SCSI connector
JP1 --- Refer to Chapter 3
Chapter 2 Installation
Before installing AEC-7730A, set up a SCSI host adapter like ACARD
AEC-67162S first. Be sure that the host adapter is shown under “Device
Manager” of “System Properties” in Windows. Now follow the instructions
below to install.
Step 1 Connect CN3 of AEC-7730A to the SCSI adapter with a SCSI
cable.
Step 2 Connect CN2 of AEC-7730A directly to the SATA hard drive.
Step 3 Connect CN1 of AEC-7730A to the power supply.
Chapter 3 Jumper Setting
SCSI ID Setting
Pin4 Pin3 Pin2 Pin1
Pin4 Pin3 Pin2 Pin1
ID=0 OFF OFF OFF OFF ID=8 ON OFF OFF OFF
ID=1 OFF OFF OFF ON ID=9 ON OFF OFF ON
ID=2 OFF OFF ON OFF ID=10 ON OFF ON OFF
ID=3 OFF OFF ON
ON ID=11 ON OFF ON
ON
ID=4 OFF ON OFF OFF ID=12 ON
ON OFF OFF
ID=5 OFF ON OFF ON ID=13 ON
ON OFF ON
ID=6 OFF ON
ON OFF ID=14 ON
ON
ON OFF
ID=7
ID=15 ON
ON
ON
ON
8 4 2 1
O N O FF
- 2 -
- 2 -
- 1 -
CN3
CN1
CN2 (power) CN2 (data)
JP1
