8
AEC-67160M Ultra160 SCSI Adapter
Note: Usually, a color wire on the edge of cable indicates pin 1 of
connector, and a mark also shown on the adapter board.
Step 3: Find out pin 1 of the connector on your device.
Step 4: Select one available connector on the cable, then plug it into your
internal device connector aligning with pin-1 to pin-1.
Step 5: If you have two or more devices, please repeat Step 2 and Step 3
to install you remaining devices.
Step 6: Please set the last SCSI device terminator on.
Note: For terminating your internal SCSI device, please refer to
your original SCSI device supplier or manufacture.
Step 7: Identify your devices ID number, that is, you have to set all your
internal SCSI devices an unique ID number to avoid hardware
conflict.
2.3 Installing External Drives
Power Connection
For external SCSI devices, you need to connect the power core to turn on
your external device.
Cable Connection
There are two different ways to make external cable connection when
connecting to only one device or connecting to more than one devices.
1. Connecting to only one device
Step 1: Identify number of pins on the connectors, either adapter or device.
Then, prepare an external cable whose connectors match your
need, e.g. 50-pin to 50-pin, 68-pin to 68-pin, or 68-pin to 50-pin.
Step 2: Plug one end of the high-density external SCSI cable into the host
adapter connector.
Step 3: Plug the other end of this SCSI cable into one connector on the
SCSI device that you wish to connect.
