20
11.3
ALTERNATE TWO-WIRE START/STOP CONTROL
Shown below is the wiring diagram for an alternate two-wire start/stop control scheme, using one
maintained contact for RUN FORWARD and another maintained contact for RUN REVERSE.
NOTES:
1.
For this control scheme, TB-13A MUST be set to RUN REVERSE (05), even if REVERSE
direction is not required. Refer to Parameter 10 - TB13A FUNCTION.
2.
Close TB-12 to TB-2 to RUN, and open TB-12 to TB-2 to STOP.
3.
If reverse direction is also required, ROTATION DIRECTION (Parameter 17) must be set to
FORWARD AND REVERSE (02). Close TB-13A to TB-2 to RUN in REVERSE, and open TB-
13A to TB-2 to STOP. If TB-12 and TB-13A are closed to TB-2, the drive will STOP.
4.
For 0-10 VDC or 4-20 mA speed control, use one of the following methods:
1.
Program one of the TB-13 terminals (13A, 13B, or 13C) for 0-10 VDC (02) or 4-20 mA (03).
When that TB-13 terminal is closed to TB-2, the drive will respond to the selected speed
reference signal. If that TB-13 terminal is not closed to TB-2, the drive will respond to the
speed control source selected in Parameter 05 - STANDARD SPEED SOURCE. This method
must be used if it is necessary to toggle between two speed sources.
2.
Program Parameter 05 - STANDARD SPEED SOURCE for 0-10 VDC (03) or 4-20 mA (04).
This method is preferable if only one speed source is required, as this method leaves the TB-
13 terminals free to be used for other functions.
STOP
COMMON
0-10 VDC INPUT
RUN FWD
COMMON
RUN REV
0-10 VDC or 4-20 mA SELECT
COMMON
4-20 mA INPUT
1
2
5
6
12
TXA TXB
2
13A 13B 13C
14
15
2
11
25
31
30
The TB-2 terminals are internally connected to each other
