28
Installation and Maintenance
Service Manual
10. Wiring Work
10.1
3) Shape the tail of wire into ring by needle nose plier, and keep the gauge of ring in accordance with screw.
4) Use the screwdriver for tightening the terminal.
(2) The connection of stranded wire (as shown in fig 10.1.2)
1) Strip about 10mm (3/8 in.) insulation of the end of stranded wire by stripping and cutting tool.
2) Loosen the wiring screws on terminal board.
3) Insert the wire into the ring tongue terminal and tighten by crimping tool.
4) Use the screwdriver for tightening the terminal.
Unit: mm(in.)
Fig 10.1.1
Fig 10.1.2
10.0.1
