Abus TVVR41000, User Manual

Page: 99 / 316

Device menu
35
Manual Alarm
Note
The menu is used to check the recording settings
in the event of an alarm, to trigger alarm outputs
manually and to test the settings. You can then
check and correct your settings in the playback
screen.
1. Select the camera by clicking the corresponding line.
2. Click
on Trigger to switch on the alarm manually.
Trigger then changes to No for this camera.
3. Confirm the prompt by pressing OK .
4. When Trigger All is selected, then all alarms are
switched on manually.
5. Click on Clear All to switch off all alarms simultane-
ously.
HDDs
Note
The device manages up to four 3.5" SATA hard
disk drives.
Each of the installed HDDs must be initialised be-
fore the device can be used for recording. The de-
vice only detects the HDD and its assignment af-
ter initialisation has been made.
Warning
All data is deleted from the HDD during initialisa-
tion.
Ensure a data backup has been made in good
time beforehand.
Installing the HDD
1. Disconnect the device from the mains power and
open the cover.
2. Observe the applicable ESD guidelines when han-
dling electronic devices and ensure they are earthed.
3. Do not open the device in rooms with carpets or
other surfaces that can become electro statically
charged.
4. Avoid bodily contact with all components on the
PCB.
Warning
If you have questions regarding the information or
cannot find the information you need, please con-
tact your maintenance specialist.
5. Install the HDD and then connect it.
6. Reattach the cover and connect the device to the
mains power supply.
7. Switch on the device and start the HDD menu.