Abus TVVR20001, User Manual

Page: 113 / 313

Alarm
51
Handle:
Parameter Setting
Pop-up Image on Moni-
tor A message appears on the
monitor.
Audio Warning The device emits a repeat-
ing tone.
Notify Surveillance Cen-
tre Sends an alarm signal to a
PC with ABUS CMS soft-
ware. The software must be
enabled and the recorder
set to surveillance mode on
the PC.
Send Email An e-mail is sent to a spe-
cific e-mail address (see
page 48).
Trigger Alarm Output See page 51.
Schedule:
Here you can define in which period of time the reaction
to the alarm input shall be handled.
Triggered Camera:
Parameter Setting
Record Using this parameter, you can select
which cameras should be used for re-
cording after the alarm input is trig-
gered.
Enable Sched-
ule Using this parameter, you can select
on which cameras the schedule
should be activated. For example, if
you have installed the ABUS IP alarm
module, then you can use the
Secvest Key to activate guard mode
in the recorder when exiting the prem-
ises. The recording mode (duration,
motion detection, alarm) stored in the
schedule is then used. In this way,
you can activate the recorder inde-
pendently from the schedule and pre-
vent false alarms.
Ensure that the schedule is not acti-
vated initially so that it is not disarmed
during activation.