Abus TV7602, Installation Manual

Page: 59 / 203

59
Attention:
The camera comes with two light barriers to calibrate pan/tilt coordinates. If the light
barriers are not crossed for a while, it could lead to inaccuracy and the camera cannot
approach the preset positions exactly anymore.
Therefore the camera should cross the light barriers at 0° tilt and 180° pan in every tour
or pattern.
E. AUTO SCAN SET
66 + Preset button starts AUTO SCAN after setting.
1. AUTO SCAN – START ANGLE
To set start angle, press FOCUS FAR button and move joystick to the starting angle
which is needed to be memorized. Press FOCUS FAR button again to escape.
2. AUTO SCAN – END ANGLE
To set end angle, press FOCUS FAR button and move joystick to the end angle which
is needed to be memorized. Press FOCUS FAR button again is escape.
3. AUTO SCAN – DIRECTION
Auto scan direction of rotation can be set clockwise or counterclockwise.
CW: Clockwise direction (Default)
CCW: Counterclockwise direction
4. AUTO SCAN – ENDLESS
Auto Scan rotation can be set endless. Move joystick rightwards in order to select ON.
The default setting is OFF.
5. AUTO SCAN – SPEED
Auto scan speed can be adjusted from 5° per second up to 35° per second.
The default setting is 10°/S.
6. AUTO SCAN – DWELL TIME
This menu item means the delay time when an angle is arrived and the dome starts to
drive back to another angle.
This menu item does not affect when endless is adjusted.
Move joystick to the left or right in order to adjust dwell time. Dwell time can be adjust
from 01 second to 99 seconds and the default setting is 03 seconds.
AUTO SCAN SET
START ANGLE : XXX.X.XX.X
END ANGLE
: XXX.X.XX.X
DIRECTION : CW
ENDLES : OFF
SPEED : 10
°
/S
DWELL TIME : 03
SAVE AND EXIT
EXIT
DEFAULT SETTING