Abus TV7182, Installation Instructions Manual

Page: 10 / 25

5
7. Installation
Proceed as follows when installing the camera.
1. Select a suitable place to mount the camera.
2. Connect the video cable (recommended type: RG59) with the BNC video
output (1) of the camera and with the output as the next connected device.
The maximum cable length must not exceed 200 meter.
3. Connect a 12VDC voltage supply to the power input (E 5.5x2.1).
4. Hold the camera at the location where you want to mount it later. Check the
orientation and viewing angle of the camera.
5. Fasten the supplied wall or ceilling mount to the desired installation location
and screw the mount into the camera housing.
6. Change the orientation of the camera bracket if necessary by slightly
loosening the fixing screw and changing the position as required. Then tighten
the fixing screw so that the camera remains in the desired position.
8. Technical Data
Model TV7182 TV7183
Video norm PAL
Image sensor 1/3‘‘ SONY HAD CCD Sensor
Pixel (total) 537(H)x597(V) 795(H)x596(V)
Pixel (effective) 500(H)x582(V) 752(H)x582(V)
Min. illumination 0.05 Lux (IR off)
0 Lux (IR on)
Infrared sensitivity 400-850 nm
TV lines / Pixel 420 TVL / 291000 480 TVL / 437000
Infrarot LEDs 35 LEDs
Infrared range 15 meter
IR activation Automatic, under 10 Lux
Synchronisation Internal
Video signal
1Vss / 75 Ohm, composite
Signal-noise-ratio > 52 dB
Day/night switching Black/white under 2 Lux
Whitebalance 2400K – 11000K
Lens 3.6mm / Miniature lens / F2.0
Auto-Iris 1/50s – 1/100000s
Backlightcompensation Active histogram plus windows weight BLC
Gamma 0.45
Operating temperature
-10°C - +50°C
Protection grade IP68
Size / weight Ø60 x 50 mm / ca. 430 g
Voltage / max. current 12 VDC / max. 350 mA 12 VDC / max. 400 mA
Security-Center, ABUS Group, D-86444 Affing, Germany
www.abus-sc.eu , info@abus-sc.eu