10 Display and setting elements
15
Wireless board:
1. Press SELECT on the wireless PCB until the eighth LED from the bottom
lights up.
2. Push the SET button
once
to get to menu 8. All blue LEDs start flashing.
This signals that the wireless module is ready to restore itself to the factory
settings.
3. Press and hold down the ESC/DEL button for about 4 seconds until the
flashing stops and the alarm centre beeps twice.
The factory settings are now restored. You are now in the main menu again.
The web server settings are retained. Only all the trained wireless
components and their settings are removed.
To exit programming mode, press ESC/DEL until the alarm centre starts to beep
(about once per second). Close the housing or press and hold down the cover
tamper contact (SW4, underneath ESC/DEL) for about 4 seconds until it beeps twice.
The data is saved in an EEPROM.
10.7 Relay and transistor outputs
The relay output allows wired components to be switched.
Maximum switching power: 1,25 A ; 60 VDC
The transistor outputs are used for connecting
an optional GSM dialler.
Swiching power: 200mA.
Select a positive trigger polarity for controlling a
GSM/PSTN dialler. Connect the 0V with the 0V
of your dialler to establish equipotential
bonding. In an activated state, the output is at
12V. For the numbering, refer to the chapter
on “Setting elements and connections on the
IP board”.
Power supply for the GSM/PSTN dialler is not possible using the Secvest IP
power supply unit included.
