Abus FUBE50061, Installation Instructions And User Manual

Page: 55 / 188

EN 23
Note
If you are using this wireless key switch with the Secvest
2WAYFU800x
(
software version 5.xx.yy) or with the Secvest
FUAA50XYZ, you must reset button 4 to “Disarm all”.
Note
If you wish to use the wireless key switch to internally arm a partition or
switch outputs, go to the installer menu of the wireless alarm panel and
select “Other components

Wireless control panel

Edit wireless control
panel”, and select the relevant wireless control panel. Now you can
reassign buttons 1 and 4. The following options are available:
•
Arm all
•
Internal arming
•
Disarm all
•
Output z (on, off, switch or pulse)
The button codes transmitted by the wireless key switch are not freely
programmable.
Now continue with installation from point 12 of section 7.
8.7.3. Operating mode
The left button (11) of the wireless key switch is used for arming, and
always transmits the code “Button A”.
The right button (12) of the wireless key switch is used for disarming, and
always transmits the code “Button B”.