Abus eytron TV8910, Installation Manual And Operating Manual

Page: 35 / 135

8
First steps with the 4-channel digital recorder
To start the 4-channel digital recorder:
1st Step: Insert the hard disk as described and lock the HDD frame.
2nd Step: Connect all cameras with the camera inputs on the rear of the digital recorder.
3rd Step: Connect the monitor output of the digital recorder with the monitor input of your monitor.
4th Step:
Use the transformer supplied (230V AC/12V DC) to supply the 4-channel digital recorder with
electricity.
5th Step: The digital recorder is now switched on.
The digital recorder now checks for correct installation of the hard disk and the number of
connected cameras. You hear an activation tone.
6th Step: After about 5 seconds, the digital recorder ends the test. The beep tone is deactivated.
Camera inputs at which no video signal is detected are shown black on the screen. Deactivated
camera inputs are shown blue on the screen.
The 4-channel digital recorder is now ready for programming.
Display of other camera inputs
To switch between camera inputs, press the corresponding camera button (2).
The digital recorder shows the video pictures of the selected camera input. If no video signal is detected from
the selected camera input, the picture is black.
Changing the display format
Press the Quad button (1) to switch from full-screen mode (one camera input as full-screen)
to quad mode.
Automatic switching of camera inputs
This function enables automatic sequencing of the displayed camera input.
The sequencing interval is 5 seconds and cannot be adjusted.
To activate this function, press “SEQ” (3).
To exit this function, select another display format with the “Quad” key (1) or a camera input as full-screen
with the corresponding camera key (2).