10
6. Description of the camera
(1) Video output connector (VIDEO OUT)
BNC output. This connector is for connecting the camera video signal to the VIDEO IN
connector of, for example, the monitor (composite signal: 1Vp-p).
(2) Power input
12V DC voltage supply. Approved for DC voltage are class 2 power supply units
only. Ensure the polarity is correct.
7. Installation
Proceed as follows when installing the camera.
1. Select a suitable place to mount the camera.
2. Connect the video output (1) of the camera via the video cable with the
video input of the next device. The maximum cable length should not exceed
200 m.
3. Connect the 12V DC power supply supplied to the power input of the
camera (2).
4. Hold the camera at the location where you want to mount it. Check the
orientation and angle of the camera.
5. Fasten the supplied wall or ceiling mount (4) to the desired installation
location and screw the mount into the camera housing (3).
6. Change the orientation of the camera holder if necessary by slightly
loosening the fixing screw (5) and changing the position as required. Then
tighten the fixing screw so that the camera remains in the desired
position.
