Light show options
Page 14
Page 11
Strobe mode
STR
ON
When On, the light show may use strobing. When Off, strobing is disabled in
light show mode. (If SLO mode is on, strobing is also disabled).
This option only has any effect on the “Controller” VR in light show mode. It
has no effect when the VR is controlled by DMX or when it is a light show
slave.
Sound mode
SOU
ON
When On, light show is triggered by sound. When Off, it is triggered by a
timer. This option only has any effect on the “Controller” VR in light show
mode. It can be useful to demonstrate the VR, or if used with “SLO” mode,
to provide a relaxing slow-changing light show, especially if Colour Snap and
Gobo Snap are set to Off.
Enhanced Light Show mode
ELS
OFF
When Off, the VR restricts the light show patterns it uses to those which look
good on only 2 heads (this avoids both heads going to blackout at the same
time). If you have 3 or more heads set to different light show groups, turning
this option on will produce a more dynamic light show. This option only has
any effect on the “Controller” VR in light show mode.
Setting feature options
Hold the “MODE” button for 3 seconds to enter setup mode (this is to
prevent accidental option changes). Press MODE briefly to step through
options. A long press of the MODE button while you are in the setup mode
will exit setup and go back to normal.
The setup mode times out if you don’t press a key for about 3 minutes. If the
display blank option is turned on, the display will turn off before this, but you
can carry on setting options by pressing a button to redisplay the current
option.
If the display is blanked, the first keypress turns the display back on, but has
no other effect.
The display settings shown below are the factory default settings.
Locking the keypad
If the VR is located in a position where people could tamper with the settings,
you can lock the keypad. Hold down the MODE button while turning the
power on. The display will show LOC. If you press any of the buttons the
display will show LOC and the button will not have any effect.
The keypad will remain locked until you unlock it by holding down the MODE
button while turning the power on. The display will then show UNL.
DMX Channel set
CHA
001
Press Left button to set 100’s, middle button to set 10’s and right button to
set 1’s. The new channel setting will not take effect until you press the MODE
button. The VR will exit setup mode automatically when you have finished
setting the DMX channel.
If you try to set an invalid channel, the VR will display ERR.
Mirror pan invert
I-P
OFF
Press any of the small buttons to change the option. When this option is On,
the left-right movement of the mirror is inverted.
courtesy of
www.sxsevents.co.uk
Phone: 0870 080 2342
email: [email protected]
Event production and Audio-Visual Services
www.sxsevents.co.uk
