GREY, WHITE, BLACK FREESTANDING 1000mm
1. Assemble the barrier by placing the large cover over the heavy black baseplate.
2. Remove the bolt from the end of the upright, fit the washer onto the bolt and place it through the central hole of
the base plate and cover and into the end of the upright. Tighten securely with the Allen Key provided.
3. Place the barriers in position to protect the artwork allowing 1.5 to 2 metres between each. Be sure to check the
cord does not ‘droop’ between barriers.
4.
Remove the top caps using your finger or a small screwdriver and tie a simple ‘granny’ knot in the end of the
elasticated cord. Pull it very tight and cut off any excess cord close to the knot.
5. Push the knot into the recess in the top of the upright with the cord exiting through one of the slots and replace the
cap.
6. Pull the cord tight to the next barrier with enough tension to make a straight line and push into the slots: straight
across if it is a straight line or at right angles if it is at a corner.
7. Repeat step 5 for the last barrier or use a wall terminator.
Note:
In an installation where the object is completely surrounded, instead of two separate knots tie the two ends
together with a reef knot, pull very tight and cut off the ends. If required cut off one of the cap legs to
accommodate the size of this knot. A line of barriers can also end with the cord returning to the wall by using a
wall terminator.
