THINGS YOU OUGHT TO KNOW
WHEN YOUR REFRIGERATOR IS INSTALLED
INSPECT
Inspect for shipping damage. If unit is damaged or parts are missing, notify your Absocold dealer at once.
INSTALLATION REQUIREMENTS
Remove all packing material and tape. Install on a level floor or well
-
supported counter. Avoid any direct sunlight, heat source, or moisture. This
refrigerator is designed to be
freestanding
—
that is, the appliance is to be installed at least
2”
from the wall and the cabinet bottom is at least
¾
”
to
1”
above
the floor or carpet, in order to let the air circulate freely around the refrigerator.
ELECTRICAL REQUIREMENTS
115 volts, 60 Hz. 15 amps.
ELECTRICAL GROUNDING
(for 115
-
volt models only)
Must be grounded. Uses 110
-
115 volts, 60 Hz.
(60 cycles A.C.) Do not use extension cord. Use three
-
prong plug, with three
-
prong grounded wall outlet.
Unless the above grounding method is followed, you are not protected against severe or lethal shock, in the event of a short circuit of an electrical
component or wiring of refrigerator.
CAUTION
Should you unplug refrigerator, allow at least three minutes before restarting in order to allow the start relay to function properly.
USE AND CARE INFORMATION
•
TIPS ON EVERYDAY USE AND CARE
TO CONTROL TEMPERATURE: Normally the Temperature Control Knob should be set at the 3 position. The refrigerator and freezer compartment
temperature can be adjusted colder or warmer by turning the Temperature Control Knob. Colder temperature can be achieved by turning the Control
Knob
clockwise towards the
MAX position. Warmer temperature can be selected by turning the Control Knob counterclockwise towards the 1 position.
DEFROST: For the most efficient operation of your refrigerator, defrost it whenever a ¼
”
-
thick layer of ice frost forms (except for frost
-
free models).
When defrosting. Turn off control. Remove all food from the refrigerator. Do not use heater devices to speed defrosting. Do not scrape or use sharp
objets in the ice storage compartment. Let frost melt. Pan of warm water in ice storage compartments speeds defrosting. Empty defrost tray. Reset cold
control. Replace food.
FOR ALL CLEANING: Mix 2 tablespoons baking soda or mild soap with 1 quart warm water. No strong cleaners, scouring powder or pads should be
used. For persistent odors, Absocold
’
s Services Department has odor removal products. Vacuum the tubing on outside back when dusty.
•
THINGS TO REMEMBER
1.
Allow 24 hours for your refrigerator to reach a new temperature setting.
2.
The motor will start and stop often. It must do so in order to maintain the temperature you select.
3.
Keep your refrigerator reasonably level.
4.
Unplug refrigerator before doing anything with its electrical system (even changing a light bulb).
•
BEFORE CALLING FOR SERVICE
Check plug and outlet. Test outlet with lamp or other device. Be sure control is on. Read all Use & Care Information. Your questions may be
answered. If not, find your model number (on upper back of refrigerator or inside the refrigerator affixed to the inner liner surface on the right
-
hand side).
Refer your model number and the problem to Absocold at (800) 843
-
3714 or (765) 935
-
7501.
DANGER—ELECTRICAL SHOCK HAZARD. Disconnect power before servicing.
WARNING!
•
Your refrigerator should be connected directly to a grounded electrical wall outlet.
No extension cords, multi
-
connection bars, etc. should be used.
•
In case of prolonged power outage or an electrical disconnect of any type, please check your refrigerator for spoiled food.
ENERGY SAVING TIPS
-
WAYS TO SAVE POWER, SAVE MONEY, AND STILL ENJOY YOUR REFRIGERATOR
•
Reduce door openings.
•
Close the door as soon as you can.
•
Keep coils on back of the refrigerator clean.
•
Don
’
t put hot foods in refrigerator.
•
Keep your refrigerator away from stoves and other heat sources.
